Professional Solution Provider for Iron and Steel Industry -- Zitai New Material
How printing plate trimming works
Release time:
2023/10/30
When encountering the situation that the size of the printing plate is not suitable, we can use the trimming way to change the size, and trimming is also relatively simple. Although this operation is said to be simple, but also need to be carried out under the premise of the correct operation, here we come to a specific introduction to its trimming should be how to operate?
When encountering the situation that the size of the printing plate is not suitable, we can use the trimming way to change the size, and trimming is also relatively simple. Although this operation is said to be simple, but also need to be carried out under the premise of the correct operation, here we come to a specific introduction to its trimming should be how to operate?
銆€銆€1, trimming is generally realized before the positioning of the steel plate. Of course, it is also true after installation, just the top of the plate needs to leave enough clearance.
銆€銆€2銆丳lace the trimming tool on the chassis of the printing plate, hold the terminals of the steel plate with the tool and fold the chassis upward. When the flat plate is used on a roof with a slope of less than 1/5, bend the bottom end of the chassis at the lower end slightly downward to ensure that the rainwater drains along the color steel terminals. Meanwhile, the downward folding operation must be carried out after the steel plate is fixed, otherwise this operation will be hindered.
銆€銆€3. When folding down the side end of the steel plate, open the opening of the prying tool appropriately, clamp the tool on the end of the chassis and push it inward as far as possible. When the tool is tight against the end of the chassis, crank the handle about 200°, thus creating a downward fold at the end of the stamped plate. In this way, the plate trimming is completed.
銆€銆€The above is some introduction about the trimming operation, through the trimming is possible to change the size of the printing plate, but after the trimming, the trimmed burrs must be polished in time to avoid burrs.
Related News
Reasons affecting color coated galvanized sheet and storage methods
Color coated galvanized sheet in daily life has been widely used in different areas and different parts of use, using the same amount of galvanized color galvanized sheet, its service life will be very different, so for different situations, in the treatment up is also different, so what is the cause of it, let's next come together to understand it.
2023-10-30
How printing plate trimming works
When encountering the situation that the size of the printing plate is not suitable, we can use the trimming way to change the size, and trimming is also relatively simple. Although this operation is said to be simple, but also need to be carried out under the premise of the correct operation, here we come to a specific introduction to its trimming should be how to operate?
2023-10-30
Printed color steel plate surface without luster reasons and treatment methods
Printed color steel plate surface are more glossy, and cause no luster reason is various, we should pay attention to the production and processing time to find the cause of no luster reason and solve the problem, otherwise the use of the product will be affected to some extent, the following to give you an introduction to the surface of the plate no luster reason and processing method.
2023-10-30
COPYRIGHT ©2023 Shandong Zitai New Material Co., Ltd. |SEO Tags| 鍥介檯绔欏缓璁撅細涓紒鍔ㄥ姏 娣勫崥 澶栬锤Google鎺ㄥ箍